July 2023 Tip: Calculating Gibs and Dovetails

By

Using Common Angles and Standard Pins to Calculate Gibs and Dovetails

In this PDF download, you will receive standard pin diameters in fraction and decimal form from 3/64 inch (0.04688) to 2inches (2.000) for 45- and 60-degree angles for E, F, and G.

Angle and Pins for gibs and dovetails

Thanks for visiting www.MachinistKalc.com today. These tips are some of the best tools a machinist can have. I also have more Machinist Tips available. 



Comments

Post a Comment

Popular posts from this blog

May 2021Tip: Find the Distance Across Corners of Hexagons, Squares, and Octagons

By
Image
These charts have pre-determined sizes and also the formulas to find the Distance Across Corners of Hexagons and Squares . Although Octagons are not included in this PDF, I have listed the formula below for that as well. Download at the hyperlink above or  Contact me to receive the full PDF. It's free! Sample of PDF you will receive Hexagon:  D = Distance across Corners d = Size of Hexagon Formula: D = 1.1547d Square: E = Distance across Corners d = Square Size Formula: E = 1.4142d Octagon: O = Distance across Corners d = Size of Octagon Formula: O = 1.082d Thanks for visiting  www.MachinistKalc.com  today. I'm pleased to provide one or two new helpful tips for you each month.
Read more

February 2021 Tip: Drill Tip Length Calculator

By
Image
  This is a Drill Tip Length Calculator used to calculate from the tip to the OD of the drill of  60, 82, 90, 118, 120, 135 degree drill tips.  Just enter the angle and the drill diameter, and the length will automatically be calculated in the tip length cell. If you have Excel on your iPhone, this will work. No need to buy my Drill Point Program. You may download the Drill Point Program . Or  contact me if you would like this free Excel sheet to be sent to you.    Thanks for visiting  www.MachinistKalc.com  today. I hope you enjoy this and all future machinist tips I'll be offering frequently on this site.
Read more